1. The operator must be trained and then posts, must be familiar with the use of different cutting machine! Properties and general equipment maintenance methods. The types of non-personnel shall not operate freely.
2. good labor protection before the start, some auxiliary tools and materials ready for operation (spatula tool operational requirements cartons, paper tubes, paper cutter, tape, etc.) and put the machine in a suitable location.
3. To ensure that the equipment in a safe state, open electrical or gas switch, check whether the circuit phase gas path is smooth, test run the machine to check for electric and pneumatic Mechanical equipment is operating properly. Mechanical protective equipment is perfect. During operation to prevent scratching or crushed into · · chain · rotating drum, and other gear.
4. spatula: according to operational requirements and accurate adjustment of the knife away, pay attention to the direction of the blade. If necessary, put a knife to remove the bottom rearrangement knife, the knife is not sharp or have a gap to actually repair replacement.
5. The survey static elimination facilities and connect the machine ground to ensure that the operation to get rid of static material. The audience machine laid waste to prevent dust absorption.
6. attention to safety on the material. The material is pushed to the right position to inflate, the rotational direction of the material can not pay attention to the reverse.
7. paper and wear on the side: the material in the direction of unwinding from a device set to wear to the winding, and adjust the position of the edge correction, when trimming on both sides to ensure that the finished product glue, must pay attention when feeding correction stroke. Be sure to travel on to the intermediate correction, run-time to pay attention to correcting the side, there will be less than when the stroke cut edges to be processed immediately.
8. put on the job requirements of the paper tube on the winding shaft alignment material. Double-sided adhesive stickers need to be a good double-sided adhesive stickers, adjust the appropriate winding tension and unwinding tension, trimming winding.
9. In the winding process to strict inspection of product quality, do not put defective or stolen goods or scrap and other products into the edge of the roll, while strictly controlling the number of meters
10. To stop unloading materials hand and lift the product from coming out of the shaft flatulence, inkjet screen material must take the gloves can not leave fingerprints on the product.
11. make the appropriate sound packaging according to production requirements, including Labeling plus wrapping paper or film, sealing · batch number and so on.
12. Turn off the power to shut down gas supply *, and the necessary cleaning maintenance machines, try not to use excessive roll Knife, glue use solvents on the device to wipe clean.
13. Problems encountered during the job, stop processing principle, can not be sure to slow down the processing of careful handling.