First, install the finishing device and tricks
1, the installation handle: the box with a handle set into the prepared binding machine axis position on the right side (note: a handle operating angle), with locking screw tightened.
2, paper consumption: must be determined in accordance with the instructions provided for each type of paper, can not be excessive. Doing so may cause the following adverse conditions:
① handle the pressure high, wearing a paper barrier, can not penetrate.
② margin uneven, prone to roll paper edge angle. ③ square shaft causing distortions, resulting in shortening the life of the binding machine.
3, adjust the margins of the paper, the principle is: according to the circle of the decision to pull the margin size. The method is: adjusting adjusting screw (located behind the binding machine) scale to achieve the purpose of the margin. The rule is: pull the ring diameter, the paper margins transfer large and small diameter ring pull, transfer of small paper margins.
4, drilling methods of operation:
① paper finishing neatly, close positioning block, the paper is fed parallel to the machine, the top into place.
② left hand pressed against the paper, right hand holding the handle, push down to the blade penetrates the paper, and then lift the handle.
③ steady hands will lay out the paper, such as paper hanging phenomenon, repeated pressing the handle, you can go down to the mentioned position paper out.
5, pull ring binding method:
According to the amount of paper, choose the size of the different specifications of the ring pull the handle and slowly pushed up to open ring pull, then pull the paper insertion hole circle, slowly pull back the handle, pull the ring gear so that all the inserted paper after the hole, pull the handle in place, tighten the ring pull mouth, binding on this fitted.
Second, binding method
When binding, the pressure scaffold wheel clockwise to raise the presser foot, the binding material is placed under the presser foot, the selected location automatically release the pressure scaffold wheel pressed, then press the wheel to rotate in a counterclockwise direction scaffold after about ~ 180 ° locking, then set the needle handle is rotated counterclockwise, set the needle through the material. When penetrating into place, the lead arm will automatically set the thread hanging in the hook groove, then lift the handle up, in order, while the needle is withdrawn, the gutter will follow through after binding material in the clockwise direction release pressure scaffold wheel to complete a binding needle, repeat the above procedure, binding legislation to complete the task.
Third, the needle
Loosen the screw on the pintle, remove the buckle needle, the needle set into the tail hook hanging on custom pin fixation holes remain vertical, set into the pintle lever set in place, the pintle on the fixing screw top tight.